SERVICE SHEET
Windows and Doors
New windows and doors that seal out weather, improve light, and operate smoothly every day.
Window replacement and door installation for entry systems, patio openings, and interior doors, including flashing, trim, hardware, and finish work.
Windows and doors are where your house meets the weather. In South Florida, that means sun, rain, and wind that expose weak seals, sticky hardware, and frames that have seen better days. We replace and install openings so they close flush, shed water, and look aligned from the curb and from inside the room.
AB Design Unlimited measures each opening, confirms what the wall can accept, and coordinates removal, installation, and interior/exterior trim. Entry doors are hung with proper thresholds and weatherstripping. Windows are set plumb and square with flashing and sealants suited to the product and the exposure.

FRONT ENTRY
Wood double doors on stucco
Decorative glass panels, coordinated hardware, and a covered porch landing.
Exterior entries are measured for swing, threshold height, and sight lines before units are ordered and rough openings are adjusted.
WHY HOMEOWNERS CHOOSE THIS SCOPE
Homeowners schedule windows and doors when drafts, noise, or hard-to-turn hardware show the opening is past its useful life, or when a remodel calls for new sizes and better views.
Openings measured before ordering
Rough openings, wall thickness, and sill conditions are verified so the window or door unit you receive fits the first time. That reduces drywall patches, trim surprises, and lost days waiting on a reorder.
Weather details done in sequence
Flashing, sealants, and pan details are installed in the order the manufacturer expects. For South Florida exposure, that attention at the sill and head is what keeps water out after the first heavy rain.
Hardware and trim that feel finished
Hinges, latches, and locksets are adjusted so doors latch without lifting. Interior and exterior trim is cut tight to the new unit so the opening reads as one clean detail, not a patch around a box.

WINDOW INSTALL
Flashing visible before finish trim
A three-panel window with protective wrap on site-built siding.
Integrating tape, pan flashing, and ladder access keeps the opening weathertight while exterior cladding is completed around the new unit.

INTERIOR ENTRY
Wood double doors with leaded glass
Interior-rated pairs with matching hardware and white fluted casing.
Pairs are adjusted for even reveals at the head and jambs so daily use feels solid and quiet.

MASONRY OPENINGS
Window set in block with new sealant
White vinyl unit centered in a prepared masonry rough opening.
Perimeter seal and interior trim prep are completed so the room is ready for paint once the exterior stucco or coat is cured.
DELIVERABLES
A windows and doors project may include some or all of the work below. Your estimate lists each opening, product type, and what trim or paint is included.
- Site measure and opening verification
- Window replacement and new installations
- Exterior and interior entry doors
- Patio and sliding door systems
- Interior door replacement and hardware
- Flashing, sealants, trim, and paint touch-ups
PHASES
How windows and doors move from a walkthrough of sticky units to openings that close with confidence.
- 01Measure openings and confirm products
- 02Order units and schedule installation
- 03Remove old units and set new ones
- 04Adjust hardware, trim, and final seal
Ready to discuss windows and doors?
Tell us which windows or doors are failing and share a few photos of the openings. We will explain what a replacement should include and what to expect on site.